Basic operation en
61
▶
Allow the hot milk system to cool
down before touching it.
Requirements
¡ The milk tube is connected.
¡ The suction pipe is connected.
1. Insert the suction pipe in the milk,
e.g. Tetra Pak carton.
2. Place your pre-warmed cup under
the outlet system.
3. Press repeatedly until the dis-
play shows "Milk froth".
4. Change the setting if necessary:
‒ Use to adjust the amount.
→"Adjusting the amount",
Page62
5. Press .
a The milk froth will run out of the
outlet system.
6. Press to stop the dispensing
process.
Dispensing hot water
WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
▶
Never touch the milk system when
it is hot.
▶
Allow the hot milk system to cool
down before touching it.
Note:If the milk system has not been
cleaned, small amounts of milk may
be dispensed with the water.
Requirements
¡ The milk system has been
cleaned.
→"Cleaning the milk system",
Page71.
¡ The milk tube has been removed.
1. Place your pre-warmed cup under
the outlet system.
2. Press repeatedly until the dis-
play shows "Hot water".
3. Change the setting if necessary:
‒ Use to adjust the amount.
→"Adjusting the amount",
Page62
4. Press .
If the following message appears:
"Please remove suction hose.", re-
move the milk tube and press .
a Hot water will run out of the outlet
system.
5. Press to stop the dispensing
process.
Drink settings
Prepare a drink according to your
taste.
Adjusting the coffee strength
1. Press the symbol for your desired
drink.
2. To select the strength of the cof-
fee, press .
You can select the following coffee
strengths:
– "mild"
– "regular"
– "strong"
– "very strong"
– "doubleshot"
Note:The setting "doubleshot" is
not available for every drink and
drink volume.
Tip:For a strong taste of coffee,
select a high coffee strength when
setting a large capacity.
Selecting ground coffee
1. Press the symbol for your desired
drink.
2. Press repeatedly until the dis-
play shows "Gr. coffee".
→"Dispensing a coffee drink made
from ground coffee", Page59
To Next Page
Loading...
