Siemens FDCW221 - Resetting the SMF6120 to Delivery Status

Commissioning
Resetting the SMF6120 to delivery status
6
65 |
82
Building Technologies
009865_m_en_
--
Fire Safety
2015-11-06
6.8 Resetting the SMF6120 to delivery status
NOTICE
Resetting the manual call point with radio base to delivery status
All existing configurations are deleted.
● Only reset the radio smoke detector to its delivery status if the existing
configurations can be deleted.
● Ensure that no gateway is in configuration mode during the reset process.
Exception: The reset radio device should be logged back on to the gateway
immediately.
Figure 5: View inside manual call point SMF121
1 Reset slider 2 Alarm button
1
2