About this Document
4
Building Technologies FL-III Maintenance and Repair
CPS Fire Safety 08.2012
1 About this Document
1.1 Documentation structure
This document is part of the FibroLaser III documentation. The various elements of
the technical documentation for FibroLaser III are listed below:
System introduction and planning:
The document provides an overview of the FibroLaser III system and includes
important notes to be adhered to during the project planning.
Installation Manual:
The document includes all relevant information required for the successful
installation of a FibroLaser III system.
Operation Manual:
This document comprises all information required to commission the device with
the commissioning software FibroManager.
Maintenance and Repair:
This document contains all necessary information required for performing the
correct maintenance. Additionally, the document also contains the instructions
for repairs that may be carried out in the field.
1.2 Purpose of the document
This document “Maintenance and Repair” provides important information for the
efficient maintenance and the repair of a FibroLaser III system.
This document is limited to the controller and the sensor cable. Chapter 3
describes the work, which is required for the regular maintenance of the system.
Chapter 4 contains important information on the targeted error analysis. The
repairs on the controller and the sensor cable, which are permitted by Siemens,
are described in chapter 5 through 7.
1.3 Qualified personnel
The FibroLaser III may only be serviced and repaired in conjunction with this
documentation. This work may only be performed by qualified personnel. This
maintenance and repair manual requires a suitable professional qualification for
the performance of the maintenance and repair of modules of the safety
equipment.
Within the context of the safety instructions in this documentation qualified persons
are defined as persons who are authorised to install, earth and mark systems and
circuitry in accordance with the stipulated safety procedures.
General knowledge of electrical engineering, fibre-optics, electrical safety and laser
safety are required in order to understand the maintenance and repair manual. An
additional requirement is that the user of this manual is experienced in the usage of
a PC running the Windows operating system.
To Next Page
Loading...
