Siemens FibroLaser III - Page 8

Safety
8
Building Technologies FL-III Maintenance and Repair
CPS Fire Safety 08.2012
Additionally, sufficient measures must be taken to protect against inadvertent
reactivation. A warning sign must be placed close to the mains switch of the
controller.
Fig. 2 Warning sign
Optical fibre ends must not be directly approached to the eye or the skin.
Laser radiation emitted from fibre ends must not be focussed with optical
instruments onto the eye or the skin.
The controller must be operated with attached fibre(s). Unused E2000 optical fibre
ports of the controller must be terminated using dummy connectors.
Emission of laser radiation at the end of a sensor fibre or cable must be prevented
by using an optical termination box or a termination kit.
The laser is automatically switched on by starting a measurement. The LED’s
designated with “LASER ACTIVE / LASER ON” at the front and rear panels of the
controller indicate laser operation.
If an optical fibre sensor cable, pigtail or optical fibre is broken, it must be repaired,
terminated or replaced immediately.
DO NO
T
OPERAT
E
WORKING ON EQUIPMENT
DO NO
T
OPERAT
E
WORKING ON EQUIPMENT
DANGER
N
ame:
N
o:
D
ate:
REASON:
D
ate:
Completion Planned
THIS TAG MUST ONLY BE REMOVED
BY THE PERSONAL NAMED ABOVE
SEE OTHER SIDE
Unauthorized removal may cause harm and
may the remover liable for damage and/or
prosecution
SEE OTHER SIDE
DANGER