Siemens FLENDER H1SH User Manual

7 / 96
BA 5030 en 02/2013
7. Startup 73...........................................................
7.1 Procedure before startup 73............................................................
7.1.1 Removal of preservative agent 73........................................................
7.1.2 Filling with lubricant 75.................................................................
7.1.2.1 Oil quantities 76.......................................................................
7.2 Startup 77...........................................................................
7.2.1 Oil level 77............................................................................
7.2.2 Gear unit with cooling coil or external oilsupply system 77...................................
7.2.3 Gear unit with backstop 77..............................................................
7.2.4 Gear unit with auxiliary drive 78..........................................................
7.2.5 Temperature measurement 78...........................................................
7.2.6 Bearing monitoring (vibration measurement) 78............................................
7.2.7 Checking procedure 79.................................................................
7.3 Removal from service 79...............................................................
7.3.1 Interior preservation during longer disuse 79...............................................
7.3.1.1 Interior preservation with gear oil 79......................................................
7.3.1.2 Interior preservation with preservative agent 79............................................
7.3.1.3 Interiorpreservation procedure 80.......................................................
7.3.2 Exterior preservation 80................................................................
7.3.2.1 Exteriorpreservation procedure 80.......................................................
8. Operation 81.........................................................
8.1 General 81............................................................................
9. Faults, causes and remedy 82.........................................
9.1 General information on faults and malfunctions 82..........................................
9.2 Possible faults 82......................................................................
10. Maintenance and repair 86............................................
10.1 General notes on maintenance 86........................................................
10.1.1 General oilservice lives 87..............................................................
10.2 Description of maintenance and repair work 87.............................................
10.2.1 Examine water content of oil / conducting oil analyses 87....................................
10.2.2 Change oil 88.........................................................................
10.2.3 Clean the air filter 88...................................................................
10.2.4 Clean fan and gear unit 89..............................................................
10.2.5 Refill Taconite seals with grease 89......................................................
10.2.6 Check cooling coil 89...................................................................
10.2.7 Check air oilcooler 90..................................................................
10.2.8 Check water oilcooler 90...............................................................
10.2.9 Check hose lines 90....................................................................
10.2.10 Top up oil 90..........................................................................
10.2.11 Checking friction linings of torquelimiting backstop 90......................................
10.2.12 Checking auxiliary drive 90..............................................................
10.2.13 Check tightness of fastening bolts 90.....................................................
10.3 Final work 91..........................................................................
10.4 General inspection of the gear unit 91.....................................................
10.5 Lubricants 91.........................................................................
11. Spare parts, customerservice addresses 92...........................
11.1 Stocking spare parts 92.................................................................
11.2 Spare parts and customerservice addresses 92...........................................
12. Declarations 93.......................................................
12.1 Declaration of incorporation 93..........................................................
12.2 Declaration of conformity 94.............................................................

Siemens FLENDER H1SH Specifications

General

Brand	Siemens
Model	FLENDER H1SH
Category	Industrial Equipment
Language	English