1.
Position the Ethernet module(4) as shown.
2.
Slide the Ethernet module(4) into the opening of the option slot so that the plug
contacts(5) slot into the Ethernet switch plug connector.
3.
Make sure that the Ethernet module(4) slots into the positioning aids(7).
4.
Use the fastening screw(3) to fix the Ethernet module in the threaded hole(6).
5.
Wire up the Ethernet module according to the wiring information provided below.
See also
2 Jumper settings on the VN2001 [➙ 20]
Installation
Installation of the Ethernet modules
2
10 | 32 A6V10407862_e_en_--
To Next Page
Loading...
Need help?
General
