10
First steps
Gigaset C590/C595 / IM EN / A31008-M2101-R101-2-UZ19 / starting.fm / 22.06.2010
Version 4, 16.09.2005
Setting up the base and charging cradle (if included)
The base and charging cradle are designed for use in enclosed dry rooms with a
temperature range of +5°C to +45°C.
¤ Install the base on a level, non-slip surface in a central location in your house or
flat or mount the base or charging cradle on the wall
¢ page 85.
The phone's feet do not usually leave any marks on surfaces. However, due to the
multitude of different varnishes and polishes used on today's furnishings, the
occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u Never expose the telephone to the influence of heat sources, direct sunlight or
other electrical devices.
u Protect your Gigaset from moisture, dust, corrosive liquids and vapours.
Connecting the base
¤ First connect the tel-
ephone jack 2 and
insert the cables into
the cable ducts.
¤ Then connect the
mains adapter 1.
Please note:
u The mains adapter
must always be connected, as the phone will not operate without a mains con-
nection.
u Only use the mains adapter and phone cord supplied. Pin connections on tele-
phone cables can vary (pin connections
¢ page 81).
Please note
Pay attention to the range of the base.
This is up to 300 m in unobstructed outdoor areas and up to 50 m inside build-
ings. The range is reduced when Eco Mode (
¢ page 55) is activated.
1
1
1
2
To Next Page
Loading...
