Siemens Gigaset C595 - Setting Pauses; Changing the Pause After Line Seizure; Changing Pause After Recall Key; Changing a Dialling Pause (Pause After Access Code)

69
Connecting the base to the PABX
Gigaset C590/C595 / IM EN / A31008-M2101-R101-2-UZ19 / pabx.fm / 22.06.2010
Version 4, 16.09.2005
Setting pauses
Changing the pause after line
seizure
You can change the length of the pause that
is inserted between pressing the talk key
c and sending the number.
v Open the main menu.
*#Q5#L
Press keys.
~ Enter digit for the pause length
(1 = 1 sec.; 2 = 3 sec.; 3 =7sec.)
and press
§OK§.
Change pause after recall key
You can change the length of the pause if
your PABX requires this (refer to the user
guide for your PABX).
v Open the main menu.
*#Q5#2
Press keys.
~ Enter a digit for the length of the
pause (1 = 800 ms; 2 =1600ms;
3 = 3200 ms) and press
§OK§.
Changing a dialling pause (pause
after access code)
Precondition: You have saved an access
code (
¢ page 68).
v Open the main menu.
*#Q5#
Press keys.
~ Enter number for the length of
the pause (1 = 1 sec.; 2 = 2 sec.;
3 = 3 sec.; 4 = 6 sec.) and press
§OK§.
To insert a dialling pause: press and hold
S for 2 seconds. A P appears in the display.
Temporarily switching to
tone dialling (DTMF)
If your PABX still operates with dial pulsing
(DP), but you need tone dialling for a con-
nection (e.g. to listen to the network mail-
box) you must switch to tone dialling for the
call.
Precondition: You are conducting a call or
have already dialled an external number.
* Press the star key.
After the call is ended, dial pulsing is auto-
matically activated again.