67
Base settings
Gigaset C590/C595 / IM EN / A31008-M2101-R101-2-UZ19 / registr_sett.fm / 22.06.2010
Version 4, 16.09.2005
Repeater support
With a repeater you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Precondition: A repeater is registered.
v
¢
Ï
¢ System ¢ Repeater Mode
Press §Change§ to deactivate repeater mode
(³= on).
Protecting against
unauthorised access
Protect the system settings of the base with
a PIN known only to yourself. The system PIN
must be entered when, for example, regis-
tering/deregistering a handset to/from the
base or when restoring the default settings.
Changing the system PIN
You can change the 4-digit system PIN set on
the base (default setting: 0000) to a 4-digit
PIN known only by you.
Gigaset C595: Setting a system PIN facilitates
remote operation of the answering machine
¢ page 53.
v ¢
Ï
¢ System ¢ System PIN
~ Enter the current system PIN
and press
§OK§.
~ Enter your new system PIN and
press
§OK§.
Resetting the system PIN
If you have forgotten your system PIN you
can reset the base to the original code 0000:
Disconnect the power cord from the base.
Hold down the registration/paging key on
the base while reconnecting the power
cable to the base. Press and hold the key for
at least five seconds.
The base has now been reset and the system
PIN 0000 set.
Restoring the base to the
factory settings
When the settings are restored
u date and time will be retained
u handsets are still registered
u Eco Mode is switched off and
Eco Mode+ is switched off
u the system PIN is not reset
v ¢
Ï
¢ System ¢ Base Reset
~ Enter the system PIN and
press
§OK§.
§Yes§ Press the display key.
Please note
Eco Mode / Eco Mode+ (¢ page 55) and
repeater support cancel each other out,
i.e. if you use a repeater you cannot use
Eco Mode and Eco Mode+.
•
•
Please note
All handsets are deregistered and must
be re-registered. All settings are restored
to the factory settings.
•