Making calls in the team/executive/secretary configuration
143
Step by Step
Line seizure
Line seizure must be configured (consult your service
personnel). If automatic line seizure is configured, a
trunk is automatically assigned when you lift the hand-
set or press the trunk key.
Trunk keys
The programmable sensor keys on multi-line phones
function as trunk keys. Every sensor key programmed
as a "Trunk key" (key label: Transfer Trk) corresponds to
a trunk with the result that you can configure up to nine
trunks in OpenStage 80/80 G and up to eight trunks in
OpenStage 60/60 G.
As a team member, you can independently program the
following functions on sensor keys Æ page 91:
• Direct station select
• Join/leave group
(not available on executive phone in an executive/
secretary team)
• Ring Transfer: On/Off
(only in an executive/secretary team)
You can also program a sensor key with the function
"Forward Line" (call forwarding) for each line.
LED displays on trunk keys
LED Explanation
S
Off
– The line is in idle mode.
T
Flashing
[1]
[1] In this manual, flashing sensor keys are identified by this icon, re-
gardless of the flashing interval. The flashing interval represents
different statuses, which are described in detail in the correspond-
ing sections of the manual.
– Incoming call on the line.
– Hold reminder is activated.
– The line is on "Hold".
R
On
– The line is busy.
To Next Page
Loading...
Need help?
General