How to fix no display on Siemens Telephone?
If there is no display on your Siemens Telephone, the battery pack might be flat. Press the On-hook key until you receive confirmation. Charge or replace the battery pack.
What to do if Siemens HiPath 4000 Telephone key-stroke doesn't work?
If your Siemens Telephone does not react to key-strokes, the keypad lock may be activated. Press the hash key until you receive confirmation, then release the key.
What does de-crescendo tone sequence mean on Siemens HiPath 4000?
If you hear a de-crescendo tone sequence during input on your Siemens Telephone, it indicates an incorrect entry was made. Repeat the key sequence while watching the display, and consult the operating manual where applicable.
Why does the line "Base n" flash on my Siemens Handsets?
If your Siemens Handset displays the message "Base n" flashing, it could mean several things. First, you might be out of the base radio range or the radio signal is too weak, so try moving to a different location. Second, the handset might not be registered, so you should register it. Finally, the synchronization attempts might be too far apart, so try switching the handset off and then back on again.
What to do if there is nothing audible during a call on Siemens Handsets?
If you can't hear anything during a call on your Siemens Handsets, it's possible that the microphone and receiver are muted. This can happen if the left side of the control key was pressed accidentally. To fix this, press the "Go Back" display key to re-activate the microphone and the receiver.
What does it mean when my Siemens Handsets displays 'Connect Release No dial tone available'?
If the following appears immediately after pressing the talk key on your Siemens Handsets: Connect. Release No dial tone available; no calls can be made, it means that HiPath Cordless Enterprise is currently being used by other users. In this case, the solution is to simply repeat the call later.
What does it mean if Siemens Handsets displays 'Base 1 Outgoing and incoming calls and activation/deactivation are not possible'?
If the following appears on your Siemens Handsets: Base 1 Outgoing and incoming calls and activation/deactivation are not possible, it indicates that the mobile telephone is blocked. To resolve this, remove the battery from the mobile telephone and then re-insert it.
What does the de-crescendo tone sequence during input mean on Siemens Handsets?
If you are experiencing a de-crescendo tone sequence during input on your Siemens Handsets, it indicates that an incorrect entry was made. To resolve this, repeat the key sequence while carefully watching the display. If needed, consult the operating instructions.
How to enable ringer on my Siemens IP Phone?
If your Siemens IP Phone isn't ringing, the ringtone might be deactivated, or the 'Do Not Disturb' feature could be active. To resolve this, activate the ringer and deactivate 'Do Not Disturb'.
General| Architecture | Modular |
|---|---|
| Supported protocols | SIP, H.323, ISDN |
| VoIP Support | Yes |
| ISDN Support | Yes |
| Analog Support | Yes |
| Integration | CTI, CRM, ERP |
| Compatibility | Siemens |
To Next Page