Siemens HiPath - Page 13

HSAAP_Regulatory.fm
A31003-W1110-U101-1-7619, February 2007
HiPath Wireless Standalone Access Point V1.0, Getting Started Guide
13
Regulatory information
AP2630 Internal Antenna AP, AP2640 External Antenna AP
>
The qualification testing and results are based on above described antennas, cable
types, lengths, and connector types. Other cable lengths and connector types are
also available which are specified by the suffix part of the part numbers (ex.
SR2405135Dxxxxxx, where the xxxxxx suffix represents cable length and/or
connector type). The antenna feedline used in testing are the mininum cable length.
Longer cable may be used with losses greater than or equal to the cables used for
testing. The maximum power settings must be adjusted according to these tables.
>
If one of the following antenna is used, you must select an operating channel (on the
Advanced 802.11b/g and Advanced 802.11a tabs ) and the corresponding allowed
max power from the values listed in Table 2. DO NOT select a higher power than the
value listed in Table 2.
Antenna
Antenna
#1
Cushcraft
SR2405135
Dxxxxxx
Antenna
#2
Cushcraft
S24493DSx
xxxxx
Antenna
#3
Cushcraft
SL24513Px
xxxxx
Antenna
#4
Cushcraft
S24497Pxx
xxxx
Antenna
#5 Hyperlink
Tech
HG2458CUxx
x
Antenna
#6
Maxrad
MDO24005PT
xxxxxx
Frequency
(MHz)
Ch. No. Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
11b
241211618 171617 17
241721717 171617 17
242231818 181818 18
242741818 181818 18
243251818 181818 18
243761818 181818 18
244271818 181818 18
244781818 181818 18
245291818 181818 18
2457 10 18 18 18 18 18 18
2462 11 18 18 18 18 18 18
Table 2 FCC Antenna channel-power information