Siemens HiPath - Page 21

HSAAP_Regulatory.fm
A31003-W1110-U101-1-7619, February 2007
HiPath Wireless Standalone Access Point V1.0, Getting Started Guide
21
Regulatory information
AP2630 Internal Antenna AP, AP2640 External Antenna AP
>
The qualification testing and results are based on above described antennas, cable
types, lengths, and connector types. Other cable lengths and connector types are
also available which are specified by the suffix part of the part numbers (ex.
SR2405135Dxxxxxx, where the xxxxxx suffix represents cable length and/or
connector type). The antenna feedline used in testing are the mininum cable length.
Longer cable may be used with losses greater than or equal to the cables used for
testing. The maximum power settings must be adjusted according to these tables.
>
If one of the following antenna is used, you must select an operating channel (on the
Advanced 802.11b/g and Advanced 802.11a tabs) and the corresponding allowed
max power from the values listed in Table 5. DO NOT select a higher power than the
value listed in Table 5.
Antenna
Antenna
#1
Cushcraft
SR2405135D
xxxxxx
Antenna
#2
Cushcraft
S24493DSxx
xxxx
Antenna
#3
Cushcraft
SL24513Pxx
xxxx
Antenna
#4
Cushcraft
S24497Pxx
xxxx
Antenna
#5 Hyperlink
Tech
HG2458CUxxx
Antenna
#6
Maxrad
MDO24005P
Txxxxxx
Frequency
(MHz)
Ch.
No.
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
11b
241211618171617 17
241721717171617 17
242231818181818 18
242741818181818 18
243251818181818 18
243761818181818 18
244271818181818 18
244781818181818 18
245291818181818 18
2457 10 18 18 18 18 18 18
2462 11 18 18 18 18 18 18
Table 5 IC Antenna channel-power information