en Rails
32
:Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Removing the pull-out rails
1. Push on the tab marked "PUSH" behind the end of
the rail, and push the rail away from you (fig. !).
2. Keep the "PUSH" tab pushed back and swing the rail
out (fig. ").
3. Pull the rail out towards you until the retainer at the
back unhooks (fig. #).
4. Remove the pull-out rail (fig. $).
Use washing-up liquid and a sponge to clean the pull-
out rails. For stubborn dirt deposits, use a brush.
Fitting the pull-out rails
The rails are designed to fit on either the right- or the
left-hand side (not both).Make sure when you fit them
that you can pull them out towards you.
1. The rail must sit between the two bars (fig. !).
2. Push the retainer at the back in between the lower
and the upper bar (fig. ").
3. Push on the "PUSH" tab and swing the rail in so that
the retainer ends up between the two bars (fig. #).
4. Release the "PUSH" tab; the retainer will hook into
place (fig. $). Then pull the rail out as far as it will go
and slide it back in.
1
2
I
1
2
To Next Page
Loading...
