en Installation instructions
38
To ventilate the appliance, the intermediate floor must
have a ventilation cut-out.
The worktop must be secured to the fitted unit.
18.8 Installing below a hob
If the appliance is installed below a hob, the following
minimum dimensions must be adhered to (including
substructure, if applicable).
The minimum worktop thickness is based on the re-
quired minimum clearance .
Hob type raised in
mm
flush in
mm
in
mm
Induction hob 45 46 5
Full-surface in-
duction hob
55 56 5
Gas hob 35 46 5
1
Electric hob 35 38 2
1
Observe different national installation instructions
for the hob.
Observe the installation instructions for the hob.
18.9 Corner installation
Observe the installation dimensions and the safety
clearances when installing in a corner.
18.10 Installing the appliance
1.
Centre the appliance.
2.
Screw the appliance onto the unit.
18.11 For handleless kitchens with vertical
bar handle strips:
1.
Attach a suitable filling piece on both sides in order
to cover any sharp edges and to guarantee safe in-
stallation.
2.
Secure the filling piece to the unit.
To Next Page
Loading...
