Installation instructions en
33
5.
Place the appliance in the unit and, before pushing
it in, fold the carry handles down.
6.
Push the appliance in fully.
Do not kink or trap the connecting cable, or route it
over sharp edges.
7.
Centre the appliance.
There must be an air gap of at least 5mm between
the appliance and adjacent unit fronts.
8.
Use a spirit level to adjust the appliance so that it is
perfectly level.
9.
Secure the appliance using the wooden screws sup-
plied in the cooking compartment.
20.9 Installing the appliance under worktop
1.
Remove the angle brackets and bearing rails.
2.
Tighten the screws for the mounting brackets on the
appliance.
3.
Use a spirit level to align the bearing rails horizont-
ally and secure them in place using two screws
on the left and right .
4.
Secure the bearing rails with screws so that they are
flush with the unit.
5.
Secure the mounting brackets with screws so that
they are flush with the unit.
To Next Page
Loading...
