Siemens iQ500 TP5 Series

en Cleaning and servicing
66
Using calc'nClean
You can combine the cleaning and de-
scaling programmes using the
calc'nClean service programme. Run
the calc'nClean programme when your
appliance prompts you. The process
takes approx.43minutes.
Requirement:The brewing unit is
cleaned.
→"Cleaning brewing unit", Page63
1. Press ⁠.
2. Use and to select "Cleaning
and care" and press ⁠.
3. Use and to select
"calc'nClean" and press ⁠.
4. To start the programme, press ⁠.
a The display will guide you through
theprogramme.
5. Empty and insert the drip tray.
6. If there is a water filter, remove it.
7. Press ⁠.
8. Empty the water tank.
9. Fill a container with 0.5l lukewarm
water.
10.Add a Siemens descaling tablet to
the water and stir until the tablet is
fully dissolved.
11.Pour the descaling solution into the
water tank up to the calc mark and
press ⁠.
12.Place a container with a capacity of
min. 0.5l under the outlet system.
13.Place the end of the suction pipe in
the container and press ⁠.
a The descaling programme will run
for approx.20minutes.
14.Rinse the water tank.
15.Press ⁠.
16.If there is a water filter, insert the wa-
ter filter.
→"Insert water filter", Page57
17.Press ⁠.
18.Fill the tank with fresh water up to
the "max" mark.
19.Press ⁠.
a The programme takes ap-
prox.1minute and rinses the appli-
ance.
20.Empty and insert the drip tray.
21.Open the ground coffee compart-
ment.
22.Place one Siemens cleaning tablet
into the ground coffee compartment.
23.Close the ground coffee compart-
ment and press ⁠.
24.Place a container with a capacity of
min. 0.5l under the outlet system
and press ⁠.
a The cleaning programme takes ap-
prox. 7minutes.
25.Empty and insert the drip tray.
26.Thoroughly clean the suction pipe of
the milk system.
a The program has ended and the ap-
pliance is ready for operation.