Basic settings en
25
Basic settings
16 Basic settings
You can configure the basic settings for your appliance
to meet your needs.
16.1 Overview of the basic settings
Here you can find an overview of the basic settings
and factory settings. The basic settings depend on the
features of your appliance.
You can find more information about the individual ba-
sic settings on the display using .
Basic settings Selection
Language See selection on the appliance
HomeConnect Connect the oven to a mobile device
and remotely control it.
→"HomeConnect ", Page26
Clock Time in 24-hour format
Date Date in the format DD.MM.YYYY
Display Selection
Brightness ¡ Levels 1, 2, 3, 4 and 5
1
Standby
screen
¡ On for a limited time
¡ On (this setting increases energy
consumption)
¡ Off
1
Clock ¡ Digital + date
1
¡ Digital
¡ Analogue
Alignment ¡ Align the display horizontally and
vertically
1
Factory setting (may vary according to model)
Tone Selection
Button tone ¡ On
1
¡ Off
Signal tone ¡ Very short duration
¡ Short duration
¡ Medium duration
1
¡ Long duration
1
Factory setting (may vary according to model)
Appliance set-
tings
Selection
Fan run-on
time
¡ Minimum
¡ Recommended
1
¡ Long
¡ Very long
Pull-out system ¡ Retrofitted (if 2 or 3 sets of pull-
out rails are fitted)
¡ Not retrofitted (if shelf supports
and a single set of pull-out rails
are fitted)
1
1
Factory setting (may vary according to model)
Appliance set-
tings
Selection
Lighting ¡ On when cooking and when
opening the door
1
¡ Only when the door is opened
¡ Always off
Water hard-
ness
¡ 4 (very hard)
1
¡ 3 (hard)
¡ 2 (medium)
¡ 1 (soft)
¡ 0 (softened)
1
Factory setting (may vary according to model)
Personalisa-
tion
Selection
Brand logo ¡ Display
1
¡ Do not display
Operation after
switch-on
¡ Main menu
1
¡ Types of heating
¡ Steaming
¡ Dishes
¡ Favourites
Elapsed cook-
ing time
¡ Display
1
¡ Do not display
Dishes ¡ All
1
¡ No pork
¡ Kosher only
Regional
dishes
¡ All
1
¡ European dishes
¡ British dishes
Childproof
lock
¡ Keylock only
1
¡ Deactivated
Automatic
rapid heating
¡ On
1
¡ Off
1
Factory setting (may vary according to model)
Factory set-
tings
Selection
Factory set-
tings
¡ Restore
Appliance in-
formation
¡ Appliance information
16.2 Changing the basic settings
1.
Press in the status bar.
2.
Press the required basic setting area.
3.
Press the required basic setting.
4.
Press to select the required basic setting.
a The change is applied directly for most basic set-
tings.
5.
To change additional basic settings, use to go
back and select a different basic setting.
6.
To exit the basic settings, use to go back to the
main menu or switch off the appliance using .
a The changes are saved.
Note:Your changes to the basic settings will be re-
tained even after a power failure.
To Next Page
Loading...
Need help?
General
