22/301
Siemens Building Technologies Basic Documentation LMV5... CC1P7550en
HVAC Products 2 General 13.08.2004
Infrared flame detector. Universal flame detector for oil or gas flames. Suited for inter-
mittent or continuous operation, with integrated flame amplifier and prefabricated con-
necting cable 180 cm. Front illumination
(refer to Data Sheet N7719)
Infrared flame detector. Universal flame detector for oil or gas flames. Suited for inter-
mittent or continuous operation, with integrated flame amplifier and prefabricated con-
necting cable 180 cm. Lateral illumination
(refer to Data Sheet N7719)
Flue gas temperature sensor, for acquiring the flue gas temperature in heating plants
(refer to Data Sheet N1846)
Actuator. Nominal torque 3 Nm (reduced holding torque 1.5 Nm), running time 10…120
seconds. Control and feedback via CAN bus. Stepper motor, flush panel mounting,
Woodruff key
(refer to Data Sheet N7814)
Actuator. Nominal torque 3 Nm (reduced holding torque 1.5 Nm), running time 10…120
seconds. Control and feedback via CAN bus. Stepper motor, flush panel mounting, D-
shaft
(refer to Data Sheet N7814)
Actuator. Nominal torque 20 Nm, running time 30…120 seconds. Control and feedback
via CAN bus. Stepper motor, flush panel mounting, parallel key
(refer to Data Sheet N7814)
Actuator. Nominal torque 35 Nm, running time 60…120 seconds. Control and feedback
via CAN bus. Stepper motor, flush panel mounting, parallel key
(refer to Data Sheet N7814)
QRI2A2...
QRI2B2...
FGT-PT1000
SQM45.291A9
SQM45.295A9
SQM48.497A9
SQM48.697A9
To Next Page
Loading...
