Siemens LOGO! 12/24RC - Switching LOGO! On;Resumption of Power Supply

LOGO! Manual
A5E00067781 01
24
2.3 Switching LOGO! On/Resumption of
Power Supply
LOGO! does not have a power switch. How LOGO! re-
sponds when switched on, depends on the following:
 Whether a program is stored in LOGO!.
 Whether a program module is connected.
 Whether it is a LOGO! variant without a display
(LOGO!...RCo).
 The state LOGO! was in before power off.
The table indicates LOGO!’s response to the possible situ-
ations:
No Program
No Program
>Program..
PC/Card..
Start
I:123456
Q:1234 RUN
Mo 09:00
With stored pro-
gram from
LOGO!
&
B01
Q1
No program in
memory
(empty)
(with program)
or
B03:Par
Cnt = 0028
Par = 0300
LOGO! in RUN
(empty)
(with program)
or
I:123456
Q:1234 RUN
Mo 09:00
I:123456
Q:1234 RUN
Mo 09:00
Program in
memory
>Program..
PC/Card..
Start
(empty)
or
With program
copied from
module to
LOGO!
Before power off
After power on
(with program)
>Program..
PC/Card..
Start
With stored pro-
gram from
LOGO!
With program
copied from mod-
ule to LOGO!
Installin
g
and Wirin
g
LOGO!