51
LOGO! Manual
A5E00067781 01
The block of the first special function appears:
Trg
T
Q1
When you select a block for a special or basic
function, LOGO! displays the block of the
function. The cursor is in the block and ap-
pears in the form of a solid block. Use the
or key to select the block you want.
Select the desired block (off delay, see next diagram) and
press OK:
R
The inserted block receives the block num-
ber B02. Block B01, which has been con-
nected up to now to Q1, is automatically
connected to the uppermost input of the in-
serted block. The cursor is positioned at the
uppermost input of the inserted block.
B01
T
Q1
B02
The off-delay block has 3 inputs. The uppermost input is
the trigger input (Trg). Use this input to start the off delay.
In our example, the off delay is started by the OR block
B01. Reset the time and outputs using the reset input and
set the time for the off delay using the T parameter.
In our example, we don’t use the reset input of the off
delay. We wire it with ’x’. You learned how to do this in the
first program, but just to remind you, here is the procedure
again:
1. Position the cursor under the R:key or
2. Switch to input mode: OK
3. Select the Co list: keys or
4. Accept the Co list: OK
5. Select x: keys or
6. Accept x: OK
x
B01
T
Q1
B02
The display should now look like this:
Pro
rammin
LOGO!
To Next Page
Loading...
