Siemens LOGO! 12/24RCE - 4.3.3 Assigning devices and programs; 4.3.4 Loading the programs into the KTP400 and KTP700

4 Installation and Commissioning
House Control and Weather Sensors - LOGO! Set 11
Entry ID: 68585346, V2.1, 09/2018
20
 Siemens AG 2018 All rights reserved
4.3.3 Assigning devices and programs
Table 4-6
No.
Device
Program for the device in the zip file
1.
KTP400 weather station (Set 11)
68585346_LOGO!_Set11_weather_station_V21.ap15
2.
KTP700 (Set 10)
68585346_LOGO!_Set11_HMI_WinCC_V21.ap15
3.
LOGO! weather station (Set 11)
68585346_LOGO!_Set11_LOGO!8_weather_station.lsc
contained in the network project
68585346_LOGO!_Set11_LOGO!_8.lnp
4.
Master LOGO! (Set 9)
68585346_LOGO!_Set11_LOGO!_8.lsc
contained in the network project
68585346_LOGO!_Set11_LOGO!_v20.lnp
5.
Slave LOGO! (Set 9)
6.
LOGO! TDE (Set 9)
4.3.4 Loading the programs into the KTP400 and KTP700
Table 4-7
No.
Action/response
WinCC
1.
Start WinCC and with "Browse”, open
the project "68585346_LOGO!_
Set11 _weather_station_V20”.
Then click "Open”.
Note:
Repeat the steps of this table for the
project "68585346_LOGO!_Set11_
HMI_WinCC_V20" of the KTP700,
unless you would like to operate
Set 11 separately.
2.
Click on "Open the project view” to
open it.