LOGO! Manual
A5E00067781 01
142
The program is now also on the program module/card. You
can now remove the program module/card: Don’t forget to
replace the cover.
If there is a power failure while LOGO! is copying, you
have to copy the program again once the power has been
restored.
6.4 Copying from the Module to LOGO!
You have a program module/card containing your program.
You can copy the program to LOGO! in two ways:
Automatically when LOGO! starts up (power on)
Via LOGO!’s PC/Card menu.
Note
Please note that not all programs stored on the modules
can be read in all LOGO! variants. If necessary, read Sec-
tion 6.1 again.
Automatic copying when LOGO! starts up
Proceed as follows:
1. Switch off the power supply to LOGO! (power down)
2. Remove the cover shaft.
3. Insert the program module/card into the appropriate
shaft.
4. Switch on the power supply to LOGO! again.
LOGO! Pro
ram Modules
To Next Page
Loading...
