GENERAL ADVICE
11
On the control panel, an
indicator lamp will now be flas-
hing over the program which is
suggested. Confirm by pressing
the program button for the
suggested program. Make the
exposure.
It is recommended that the
same program is kept for the
entire examination. If you get
a flashing light suggesting a
different program, it is not necessary to accept this suggestion.
Just make the exposure. The program used for the last exposure
is maintained.
As soon as you press a button which is not blinking you leave
the auto-mode for Opdose. Always remember to check that the
auto button is pressed in when you start with the next patient.
The four programs can be set to suit the customer’s requirements
on installation.
Please refer to the Operating
Instructions when changing
program settings.
You can also choose to make the
exposure using a program which is
set manually. On the MAMMOMAT
1000/3000 Nova, you then choose
the kV value, the anode/filter
combination and the film/screen
combination (H/D button).
2
To Next Page
Loading...
