Siemens MAMMOMAT 3000 - Purpose; Tools Required; Time Required; Contents of Update Kit

1 - 1
Siemens-Elema AB SPB7-230.091.10 Page 1 of 2 MAMMOMAT 3000
Solna, Sweden Rev. 01 02.00 SPS-UD Service
General 1
Purpose 1
This document describes how to change a broken or worn locking lever for the "flying
wing".
Tools required 1
• Standard service equipment
• Clinometer with feature to measure minutes of arc (e g wyler)
• General purpose grease
• Abrasive cloth
Time required 1
Approximately 4 hours / 1 person
Contents of update kit 1
The update kit (Part No. 64 21 528) contains the following parts:
Position Quantity Description
A 1 Lever, assembled
B1 Spring
C 1 Locking pin
D 2 Locking ring
E 1 Holder
F2 Screw
- 1 Repair Instructions (this document)