External DC Power Connections
When the analyzer is powered by an external 24 VDC source, the cables are connected to a
terminal block on the upper-left part of the back wall of the electronics enclosure as shown
below.
Figure 3-9 MMO 24VDC Power Entry Connection
External AC Power Connections
When the analyzer is powered by an external AC source, the cables are connected to a terminal
block on the lower-front part of the left wall of the electronics enclosure as shown below.
Figure 3-10 MMO AC Power Entry Connection
See the
Maxum II Installation Manual
2000595-001 for information regarding proper
connection of external power to the 24V power supply.
Installation Steps
3.5 Cable Connections
Installation Manual
24 Installation Manual, 12/2019, 2000595 Rev 1
To Next Page
Loading...
