Siemens Maxum Edition II - Page 52

52 pages

To Previous Page

Appendix B - Change Log

B.1 December 2019 Changes

Installation Manual

52 Installation Manual, 12/2019, 2000595 Rev 1

Main Page

Table of Contents3
Installation Overview7
Safety Notes9
Read the Safety Manual First9
Analyzer Environment9
Figure 2-1 Typical Analyzer Shelter9
Hazardous Gasses10
Location10
Security Information11
Approved Use12
Qualified Personnel12
Installation Steps13
Custom Application Drawing Package13
Considerations for Pulsed Discharge Detector Installation13
Receiving a Crated Analyzer14
Figure 3-1 Crated Analyzer14
Figure 3-2 Uncrating Details15
Mounting the Analyzer16
Figure 3-3 Using a Lift to Install an Analyzer16
Pre-Installation Requirements17
Wall Mounting Units17
Mounting and Powering an Air Treater18
Figure 3-4 Example Maxum II Outline Drawing (Air-Bath or Airless Oven on Left and Modular Oven on Right)18
Cable Connections19
Figure 3-5 Simplified Cable Connection Diagram - no APU19
Figure 3-6 Simplified Cable Connection Diagram - with APU19
Protective Earth Ground20
Cable Connection Using Steel Conduit System20
Figure 3-7 Protective Earth Ground Symbol20
Power Connections21
Air Bath or Airless AC Input and Fuses22
Modular Oven Model Power Connections23
Customer Supplied Components25
Installing AC Power25
Signal Cables26
Automatic Purge Unit27
Utility Gas Supply Installation28
Air Supply28
Minimum Air Pressure28
FID Air Supply29
Calibration Standard Supply29
Detector Flame Fuel Supply29
Carrier Supply30
Table 3-1 Regulator Assemblies30
Heat Tracing31
Sampling System Installation31
Heat Tracing33
Sample Wetted Parts33
Returning Samples to the Process Stream33
Final Analyzer Connections34
IO Wiring35
Tubing Connections35
Initial Startup Procedures37
Inspect the Electronics Cabinet37
Preparing and Inspecting the Oven38
Establish Utility Gas Flows40
Enable Power to the Maxum II40
Leak Check the Column Oven Connections40
Check Operation of Oven Heaters41
Check Flows and Pressures at Operating Temperature42
Prepare Flame Detectors if Present43
Establish Sample Flow to the Maxum II43
Establish Communications with GCP44
Run Chromatograms and Make Method Adjustments if Necessary45
Calibrate the Maxum II45
Run the Maxum II on Process Fluid47
Check for Proper Reporting of Results47
Appendix A - PECM LED Interpretation49
Appendix B - Change Log51
December 2019 Changes51

Siemens Maxum Edition II - Page 52

Table of Contents

Related product manuals