Commissioning
Milltronics Test Chain
20 Operating Instructions, 10/2021, A5E32310082-AB
Ensure the following upon completing the exercise:
• Stop the conveyor.
• Retrieve the test chain by using the control station to raise the test chain onto the storage
reel.
• Leave the wire rope cable attached to the shackle.
• During raising, ensure the chain shackle is free to move and does not bind onto any
portion of the storage reel. Once completely retrieved, secure the free end of the chain
using the wire rope.
Remove power to gear motor
Disable the gear motor by removing power from the unit. This prevents unauthorized or
accidental release of the chain during normal belt operation. The test chains should never
be released while material is on the belt.
To Next Page
Loading...
Need help?
General