What to do if Siemens Milltronics BW100 Accessories show E8 (program) error?
If your Siemens Accessories display an E8 (program) error, it indicates a parameter value error. Verify that the entered value is valid.
What to do if Siemens Milltronics BW100 show E5 (run) error?
If the Siemens Accessories displays an E5 (run) error, it means a parameter was not entered. You should check parameters P005 - P017 to ensure they are entered.
What to do if Siemens Milltronics BW100 Accessories show E9 (run) error?
If your Siemens Accessories displays an E9 (run) error, it means the auto zero is out of range. Perform an operator-initiated zero.
What to do if Siemens Milltronics BW100 Accessories show E2 (run) error?
If your Siemens Accessories display an E2 (run) error, it means the totalizer resolution is too low. Increase the value using parameters P631 - P639.
What to do if Siemens Accessories show E3 (run) error?
If your Siemens Accessories is showing an E3 (run) error, it indicates that the zero is out of range. Consider performing an initial zero using P377.
What to do if Siemens Milltronics BW100 Accessories show E4 (run) error?
If the Siemens Accessories displays error E4 (run), it indicates the span is out of range. Consider setting an initial span using parameter P388.
What to do if Siemens Milltronics BW100 show E1 (program) error?
If your Siemens Accessories displays an E1 (program) error, enter the access code into P000.
How to fix E6 (run) error on Siemens Milltronics BW100 Accessories?
To resolve the E6 (run) error on your Siemens Accessories, perform a zero calibration.
How to fix E7 (run) error on Siemens Milltronics BW100?
To resolve the E7 (run) error on your Siemens Accessories, perform a span calibration.
Special attention to warnings and notes for personal safety and product protection.
Detailed layout of terminal blocks for AC/DC power and signal connections.
Instructions for connecting AC and DC power to the BW100 unit.
Procedures for Master Reset, Load Cell Balancing, Quick Start, Zero, and Span Calibration.
Detailed steps for performing Zero and Span calibrations for accurate measurements.
Performing tests to verify and adjust span calibration accuracy with actual material.
Procedures for Routine and Initial Zero and Span calibrations.
Essential parameters for initial setup before calibration and entering RUN mode.
Parameters for load cell balancing, security, factoring, and initial calibrations.
Comprehensive list of error codes, their diagnoses, and corrective actions.
General| Model | BW100 |
|---|---|
| Manufacturer | Siemens Milltronics |
| Category | Accessories |
| Display | LCD |
| Enclosure Rating | IP65 |
| Power Supply | 100 to 230 V AC, 50/60 Hz |
| Operating Temperature | -10 to 50 °C |
| Input Signal | Load Cell, Speed Sensor |
To Next Page