Page 36 Milltronics BW100 - INSTRUCTION MANUAL 7ML19985DJ01
mmmmm
Recalibration
Initial Span
Refer to
Maneuvering
on page 18 for parameter selection and value change.
Note: Perform an initial span when a calibration out of range message appears.
1 2
1 2
1 2
1 2
1 2
select P388
span calculation,
frequency count displayed
current span count = ####
invoke initial span
span deviation = ##
span deviation accepted
initial span count = ####
return to run mode
To Next Page
Loading...
