Siemens Milltronics BW100 - Start Up Procedures

7ML19985DJ01 Milltronics BW100 - INSTRUCTION MANUAL Page 17
mmmmm
Installation
Start Up
Orientation
Display and Keypad
The BW100 operates under two modes: RUN and PROGRAM. When the unit is initially
powered, it starts in the PROGRAM mode.
If the PROGRAM mode is idle, it reverts to the run mode after 10 minutes.
Note: For successful start up, ensure that all related system components such as
belt scale and speed sensor are properly installed and connected.
balance switch, SW2
balance potentiometer, P1
LCD
Keypad
1 2 3