Siemens Milltronics BW100 - Initial Zero

7ML19985DJ01 Milltronics BW100 - INSTRUCTION MANUAL Page 33
mmmmm
Recalibration
Initial Zero
Perform an initial zero if necessary when a calibration is out of range message is shown.
Refer to Maneuvering on page 18 for parameter selection and value change.
1 2
1 2
1 2
1 2
select P377
invoke initial
zero, enter 1
current zero count
zero calculation
frequency count
displayed
zero deviation
zero deviation accepted
initial zero count = ####
Perform Initial Span