Page 26 Milltronics BW100 - INSTRUCTION MANUAL 7ML19985DJ01
mmmmm
Start Up
Zero Calibration
Note: Run the conveyor for several minutes to warm up the belt and insure that it
is empty. Test weights are not used during a zero calibration.
1 2 3
1 2 3
1 2
1 2
1 2
zero calibration required
initial zero count
zero calculation,
frequency count displayed
zero deviation calculated,
initial deviation = 0
zero deviation accepted,
initial zero count = ###
Record this value for future
reference
Perform Span Calibration,
see next page
To Next Page
Loading...
