Siemens Milltronics BW100 - Span Calibration

7ML19985DJ01 Milltronics BW100 - INSTRUCTION MANUAL Page 27
mmmmm
Start Up
Span Calibration
Run the conveyor until the belt is empty and stop it. Suspend the test weight from the
scale per its instruction manual. Run the conveyor belt empty.
1 2
1 2
1 2
1 2
1 2
initial span count
Remove the test weight when the Span calibration is complete.
span calculation,
frequency count
displayed
span deviation
calculated
initial deviation = 0
span deviation accepted
initial span count = ####
Record this value for
future reference
successful entry
into run,
display rate