Operating the CD-ROM drive and the DVD drive Preparation for use and operation
A26391-K84-Z100-1-7619
29
Operating the CD-ROM drive and the DVD drive
!
This device contains a light-emitting diode, classified according to IEC 825-1:1993: LASER
CLASS 1 (LUOKAN 1 LASERLAITE, KLASS 1 LASER APPARAT), and must not be
opened.
There is an invisible laser radiation when the cover is open. Avoid exposure to the beam.
Avoid touching the surface of a CD. Handle CDs only by their edges!
Always store CDs/DVDs in their cases. You avoid dust contamination, scratches, bending
or other damage.
Protect your CDs/DVDs from dust, mechanical vibration and direct sunlight!
Avoid storing a CD/DVD in areas subject to high temperatures or humidity.
You may use both 8-cm and 12-cm CDs.
When using CDs/DVDs of minor quality vibrations and reading errors may occur.
3
2
1
1 = Power-on indicator
2 = Insert/Eject button
3 = Opening for manual ejection
Power-on indicator
The power-on indicator (1) flashes when a CD/DVD is inserted. It goes out when the drive is ready for
reading. It lights up when the drive is accessed.
i
If the power-on indicator does not go out after the CD/DVD is inserted, and continues to
flash, the CD/DVD is probably damaged or dirty.
If the inserted CD/DVD vibrates and/or reading errors occur, then it may be possible to
eliminate the vibrations or reading errors by reducing the rotating speed. Press the
Insert/Eject button for roughly two seconds. Reducing the rotating speed also saves power.
To Next Page
Loading...
