Siemens Mobile 750 - Integrated Peripherals Ports and Controllers

Advanced menu - Advanced system settings BIOS Setup
A26391-K84-Z100-1-7619
49
Integrated Peripherals - Ports and controllers
This field calls the submenu to make the settings for the ports and controllers.
Phoenix BIOS Setup
Advanced
Integrated Peripherals Item Specific Help
PS/2 Mouse [Auto Detect]
COM port: [Enabled]
Base I/O Address: [3F8 IRQ4]
IrDA port: [Auto]
Mode: [IrDA]
Parallel port [Auto]
Mode: [Bi-Directional]
Diskette Controller: [Enabled]
On board IDE Adapter: [Both]
On Board Audio: [Auto]
Base I/O Address: [220]
IRQ Channel: [IRQ 5]
Capture DMA channel: [DMA 1]
Playback DMA channel: [DMA 3]
FM I/O: [388]
MPU I/O: [300]
Joystick: [Enabled]
FM I/O: [201]
QuickPort Audio
Speaker: [Notebook]
Microphone: [Notebook]
F1 Help
↑↓
Select Item Space Change Values F9 Setup Defaults
ESC Exit
← →
Select Menu Enter Select ² Sub-Menu F10 Previous Values
Example for the submenu
Integrated Peripherals
PS/2 Mouse
This field determines whether the PS/2 mouse or the touchpad is enabled on the notebook.
Enabled
The internal touchpad is activated if no PS/2 mouse is connected. If a PS/2 mouse is
connected when the system is started up, the PS/2 mouse is activated and the internal
touchpad is deactivated.
Disabled
The internal touchpad and the PS/2 mouse are disabled.
You must set
Disabled
if you want to use an external serial mouse.
Auto Detect
The internal touchpad is activated if no PS/2 mouse is connected. If a PS/2 mouse is
connected when the system is started up, the PS/2 mouse is activated automatically
and the internal touchpad is deactivated.