Siemens Mobile 750 - Display Device Selection; TV Mode

BIOS Setup Main menu - Making system settings
46
A26391-K84-Z100-1-7619
32 Bit I/O - Access width for data transfer
This field specifies the I/O access width of data transmission between the processor and the IDE
controller.
Enabled
Data transfer is performed with 32-bit I/O commands. This enhances performance.
Disabled
Data transfer is performed with 16-bit I/O commands.
Transfer Mode
This field specifies the transfer mode for the IDE hard disk drive.
Standard
0,8 Mbytes/s to 2 Mbytes/s
Fast PIO 1
2 Mbytes/s to 4 Mbytes/s
Fast PIO 2
4 Mbytes/s to 5 Mbytes/s
Fast PIO 3
5 Mbytes/s to 10 Mbytes/s
Fast PIO 4
10 Mbytes/s to 13.3 Mbytes/s
Ultra DMA Mode - Access Speed
This field specifies the access speed for the IDE hard disk drive.
Mode 0
slow access speed
Mode 1
middle access speed
Mode 2
fast access speed
Display Device Selection
This field is used to specify the display device.
LCD&CRT
The notebook's internal display and the external display are used.
CRT
Just the external display is used.
LCD
Just the internal display is used.
TV
Output is carried out on the TV.
LCD & TV
The notebook's internal display and the television are used.
If the notebook is connected to a MobiDock and an external display is connected to the MobiDock, the
external display is used regardless of the setting in the
BIOS Setup
(CRT only).
TV Mode
This field is used to specify the display device.
PAL
Output on the TV is in the PAL standard.
NTSC
Output on the TV is in the NTSC standard.