Maintenance and diagnostics
The NW8204 diagnostic tool
Configuring the log upload
Uploading log data
Note: If the data upload procedure takes too long to be accomplished, click the
Abort Log Upload button to abort the procedure.
Note: The log file can be imported as CSV file to a spreadsheet application in
order to be analyzed by expert users (Technical Support).
Changing the active mass storage device on the fly
If two mass storage devices are available on your system (USB and SD card), you
can change on the fly the active storage device. Proceed as follows:
1. Right-click the inactive mass storage device you want to be active.
2. Select Set as Log storage.
The active mass storage device is graphically identified by a floppy disk icon.
Setting the log storage
To Next Page
Loading...
