4BMounting / Installation
30BBase attachment wet BA721
43 |
2015-05-04
Installation (Fig. 1 and Fig. 2)
1. Install the M20 x 1.5 metal cable gland(s) in the back box of the base
attachment wet.
2. Fit the back box securely to the substructure with 2 screws (detail A).
3. Screw the housing cover to the back box with the 4 screws.
4. Push the detector base into base attachment wet BA721.
You must be able to hear the detector base click into place.
5. Screw the detector base securely onto base attachment wet BA721 using
2 screws.
Removing the detector base
1. Loosen the two screws on the detector base.
2. Disengage the lock with a screwdriver ('click').
3. Remove the detector base from base attachment wet BA721.
See also
Detector heating unit FDBH291 [➙ 50]
Base attachment wet BA721 [➙ 28]
Protective cage DBZ1194 [➙ 29]
EMC-protective cage FDBZ294 [➙ 29]
Detector heating unit FDBH291 [➙ 28]
To Next Page
Loading...
