Administration
A31003-O1010-M100-3-76A9, 12/09/2007
3-66 HiPath 8000 - OpenStage Family, Administrator Manual
administration.fm
Dialing
3.7.2 Canonical Dial Lookup
The parameters given here are important for establishing outgoing calls and for recognizing in-
coming calls.
In the local phonebook, and, mostly, in LDAP directories, numbers are stored in canonical for-
mat. In order to generate an appropriate dial string according to the settings in Internal num-
bers and External numbers (-> Section 3.7.1), internal numbers must be discerned from ex-
ternal numbers. The canonical lookup table provides patterns which allow for operation.
Furthermore, these patterns enable the phone to identify callers from different local or interna-
tional telephone networks by looking up the caller’s number in the phone book. As incoming
numbers are not always in canonical format, their composition must be analyzed first. For this
purpose, an incoming number is matched against one or more patterns consisting of country
codes, national codes, and enterprise nodes. Then, the result of this operation is matched
against the entries in the local phone book.
Up to 5 patterns can be defined. The Local code 1 ... 5 parameters define up to 5 different local
area or city codes, whilst International code 1... 5 define up to 5 international codes.
Data required
• Local code 1 ... 5: Local enterprise code for the phone. Example: „722“ for Siemens Mu-
nich.
• International code 1 ... 5: Sequence of „+“, local country code, local area code, and local
enterprise node, resp. country code, area code, and enterprise node corresponding to to
one or more phone entries. Example: „+4989722“ for Siemens Munich.
Administration via WBM
Locality > Canonical dial lookup
>
To make sure that canonical dial lookup works properly, at least the following para-
meters of the phone must be provided:
• Local country code (-> Section 3.7.1)
• Local area code (-> Section 3.7.1)
• Local enterprise code (-> Section 3.7.1)
To Next Page
Loading...
