Getting to Know Your OpenStage Phone
16
Programmable sensor keys
Your OpenStage 40 has 6 illuminated sensor keys. You can assign func-
tions to them on two levels.
Depending on how they are programmed, you can use the sensor keys as:
• sensor key with function Æ page 72
• Direct destination/Direct station selection keyÆ page 73
Touch the key to activate the programmed function or dial the stored num-
ber.
Press the key to open a menu for programming it Æ page 72.
A label for the function is displayed to the left of the key; it cannot be
changed. You can define the labeling for repdial or DSS keys according to
your requirements Æ page 75.
The status of a function is shown by the LED on the corresponding sensor
key.
Explanation of LED displays for programmed sensor keys
Increase the number of sensor keys by adding a key module
Æ page 13.
Only for direct destination selection keys can you program the se-
cond level, also for direct destination selection.
LED Meaning of function key Meaning of DSS key
S
Off The function is deactivated. The line is free.
T
Flas-
hing
[1]
[1] In this manual, flashing sensor keys are identified by this icon, regardless of the flashing in-
terval. The flashing interval represents different statuses, which are described in detail in
the corresponding sections of the manual.
The function is in use. The line is busy.
R
On The function is activated. There is a call on the line.
The programmable sensor keys on multi-line phones function as
line keys Æ page 87.
Mirea, Ch
Shift X
To Next Page
Loading...
