Step by step
Making Calls – Convenience Functions
64
S Press the programmable repdial key. A connection to
the destination loudspeaker is immediately established.
^ The called party can accept the connection by lifting the
handset.
n or S If the called party presses the speaker key or the line
key (if configured), the connection is lost.
Two-way intercom to a variable destination
When using the two-way intercom in a group, the loud-
speaker and the microphone of the destination phone
are automatically switched on.
^ Lift the handset.
or
n Press the key and enter speakerphone mode.
j Enter the system code for "Speaker call-two-way" (con-
tact the relevant service personnel if necessary).
j Enter the speed dial number for the corresponding
group member.
np The loudspeaker and microphone of the destination
phone are automatically switched on.
or
S Press the "COM Spk 2way" programmed sensor key.
j Enter the speed dial number for the corresponding
group member.
The loudspeaker and microphone of the destination
phone are automatically switched on.
Two-way intercom to a fixed destination
The system code for "Speaker call-two-way" and the
speed dial number for the corresponding group mem-
ber are programmed on the repdial key Æ page 74.
S Press the programmed sensor key.
The loudspeaker and microphone of the destination
phone are automatically switched on.
Enter code!
To Next Page
Loading...
