Siemens OpenStage15 - Page 87

Enhanced phone functions
87
Step by step
Beep on auto-reconnect
You can reconnect a held call both via the CTI applica-
tion and via the phone. A beep sounds when you toggle
between an active call and a held call when the function
is active.
Prerequisite: The option was programmed by your ser-
vice personnel.
z
You can also configure this setting via the Web interface
Æ page 171.
N Press the key shown.
Select and confirm the option shown.
if nec.
j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
User
Configuration
Incoming calls?
CTI calls? f
AutoReconnect beep = No f
Yes l
Save & exit l