Siemens Optipoint 420 - Page 90

Alphabetical Reference
90
SRSR Switch To Standby Retry Count
• Maximum number of negative attempts for switching over to standby
mode.
• If all attempts fail, a further attempt is made to switch to home mode
(standard mode).
• Valid values: 1 ... 255.
• Default value  Page 109.
 Page 67
SRSR TC_TEST Expiry Timeout
• Only required if  SRSR Automatic Switch Back is activated.
• Communication platform is in standby mode (emergency mode).
• Time period after which the next attempt to set up a connection to the
Main PBX (standard telephone system) will be started.
 Page 67
SRSR TC_TEST Retry Count
• Only required if  SRSR Automatic Switch Back is activated.
• Communication platform is in standby mode (emergency mode).
• Maximum number of positive attempts for switching over from
standby mode (emergency mode) to home mode (standard mode).
• Default value  Page 109.
 Page 67
Submit Changes
• Only on optiPoint 410/420 standard/advance in conjunction with a
display
module or application module.
• Confirm the changes you have made to the parameters of the selected
program.
 Page 57
Subscriber Number
• Enter the subscriber number for the optiPoint 410/420 here.
• The number can be 1 to 24 characters long.
• This number is used as the internal telephone number.
 Page 27  Page 65
Subscriber Password
• This password allows you to transfer the subscriber number and the
configuration settings of your telephone to another telephone (mobile
logon).
• Valid values: Alphanumeric
• Minimum length: 6 (for more information, see  Password Functions)
• Maximum length: 20
 Page 27  Page 65