Installing/Mounting
3.4 Control Unit installation
PM250 Power Module
Hardware Installation Manual, 09/2012, A5E01003502B AD
29
3.4 Control Unit installation
Fitting the CU to the PM
The Control Unit is snapped onto the Power Module as shown in the figure below. To
disconnect the CU push the release button on top of the PM.
The process of fitting the Control Unit to the Power Module is the same technique
independent from the type of Control Unit or Power Module.
Figure 3-9 Fitting the Control Unit CU240S to the Power Module FSC
Siemens Parts
To Next Page
Loading...
