Need help?Do you have a question about the Siemens S120 PM240-2 and is the answer not in the manual?
General| Protection Class | IP20 |
|---|---|
| Frequency Range | 0 Hz ... 650 Hz |
| Control Technique | Vector Control |
| Communication Interface | PROFIBUS, PROFINET, USS, Modbus RTU |
| Relative Humidity | 5 ... 95 % (no condensation) |
| Frame Size | FS A to FS F |
| Input Voltage | 380 ... 480 V 3 AC |
| Output Voltage | 0 V ... Uinput |
Procedures to prevent risk of serious accidents, including leakage current and earth connection.
Procedures to avoid damaging the inverter, including voltage limits and idle periods.
Description of PM240-2 blocksize format and its components.
Safety warnings regarding overheating due to insufficient ventilation and installation clearances.
Requirements for EMC compliance including line filters and installation conditions.
Safety instructions regarding fire risk, burns, and damage from braking resistors.
Description of the CU310-2 controller for single drives and its interfaces.
Safety warnings for CU310-2, focusing on ventilation and parameterization risks.
Rules for connecting power supply, inverter output, braking resistor, and earth.
Safety precautions related to power wiring, earth connection, and fuses.
Rules for EMC compliant wiring between motor and inverter, including shielding.
Procedure for saving modified parameters from RAM to ROM to prevent data loss.
Procedures for inverter commissioning, including self-learning and calibration.
Procedure for acknowledging and clearing faults and alarms via the BOP panel.
List of anomaly codes, their causes, and suggested solutions.
Further list of anomaly codes, causes, and solutions for inverter errors.
Additional anomaly codes, causes, and solutions for inverter faults.
Final list of anomaly codes, causes, and solutions for inverter issues.
To Next Page