Connecting
4.6 Access to power and motor terminals
PM250 Power Module
36 Hardware Installation Manual, 09/2012, A5E01003502B AD
4.6 Access to power and motor terminals
Access to power and motor terminals
The terminals for frame size C can be accessed directly, without removing any cover.
Figure 4-1 Access to power and motor terminals on FSC
Frame size D, E and F terminals covers are accessed by releasing the latch on the side of
the terminal covers with a suitable flat-bladed screwdriver. The cover can then be pushed
upwards and locked into position, as shown in the figure below.
Figure 4-2 Access to power and motor terminals on FSD, FSE and FSF
To Next Page
Loading...
