Siemens PM250 - Page 55

Accessories
7.1 Reactor and filter
PM250 Power Module
Hardware Installation Manual, 09/2012, A5E01003502B AD
55
Installing the line filter as lateral mounting component
The line filters for Power Modules with a rated power (HO) of more than 11 kW and line
filters from third party suppliers have to be mounted laterally.
0RXQWLQJ
VXUIDFHRU
FDELQHWZDOO
/LQH
/LQHILOWHU
0RWRU
L1 L3
L1’ L3’
/
3(
/ಬ 3(ಬ
8
9
:
3(
0
3RZHU0RGXOH
8 9 : 3(
8 9 : 3(
Figure 7-3 Connecting the line filter as lateral component
Shielded cables must be used from the line filter to the motor. The filter has to be installed as
close as possible to the line entry of the cubicle.
Technical specifications of the line filter
The major electrical specification of the line filter is the same as for the suitable Power
Module. This applies to:
● line voltage
● line frequency
● rated current
The admissible ambient conditions of the line filter are the same as for the suitable Power
Module. This applies to:
● storage and transport temperature
● operating temperature
● relative humidity
● shock and vibration load
Siemens Parts