Incoming Inspection
Safety Notes
DANGER
Danger during incoming inspection.
If you do not comply with the safety notes, this will result in death, severe injury, or considerable material
damage.
²
Comply with all given safety notes when carrying out the incoming inspection.
²
If you identify a defect during incoming inspection, do not correct it yourself. Repack the device and
return it to the manufacturer, stating the defect. Use the original packaging or transport packaging
that meets the requirements.
Siemens recommends that you check the device and the connectors which are not assembled.
Double Pole/Neutral Fusing
[dwfusesa-191211-01.tif, 1, en_US]
CAUTION
The fuse is used in the neutral of single-phase equipment either permanently connected or provided with a
non-reversible plug.
After operation of the fuse, parts of the equipment that remain energized might represent a hazard during
servicing.
If you do not comply with the safety notes, this will result in medium severe or slight injuries.
²
Comply with all instruction in order to avoid moderate or minor injuries.
Performing a Follow-Up Inspection on a Device
²
Visually check for external damage as soon as you have unpacked the devices; they must not show any
signs of dents or cracks.
Checking Rated Data and Functions
²
Check the rated data and functions using the complete order designation/the product code. The Equip-
ment Manual contains all technical data and a description of the functions.
²
Check the information provided on the name plate too. The device features a product label sticker, which
contains the technical data.
²
Make sure that the rated data of the device properly matches the system data. You can find the neces-
sary information in the Equipment Manual.
1.3
1.3.1
1.3.2
1.3.3
Safety Instructions
1.3 Incoming Inspection
12 Smart Communications, PowerLink 100 and PowerLink 50, Product Information
E50405-U53-X-B3-7670, Edition 11.2014
To Next Page
Loading...
Need help?
General
