PowerLink 100 CFS-2 Part
The ports for the external interfaces are mainly centralized on a connector panel. It is connected via the back-
plane with the CFS-2 part, and located between the PLPA and the CFS-2. For VF and telephone channels
Sub-D 37 pin, and for RS232 channels Sub-D 25 pin sockets are existing, which are accessible from the
front.
The module frame for the carrier frequency section (CFS-2) consists of a 19” module rack. It contains the
power supply (PSCFS), the central signal processing module (CSPi), and depending on the configuration
max. 2 alarm modules, up to 2 integrated SWT 3000, as well as max. 3 VF interface modules (VFx) and
optional a versatile multiplexer vMUX.
At the right-hand part of the frame, module slots are located for the mounting of the modules CSPi, VFx and
vMUX in double-height euro card format. The modules have a common front cover with a cut-out for the
service interface and the displays resp. operating elements of the CSPi module
Alongside on the left, the slot positions for the power supply and the 2 alarm modules are located.
The mounting positions for the integrated SWT 3000 can be equipped with the processing unit PU4 and 2
interface modules IFC.
NOTE
For more details concerning the functional description of the PowerLink and integrated SWT 3000 we refer
you to the PowerLink Equipment Manual.
2.6
PowerLink Description in Brief
2.6 PowerLink 100 CFS-2 Part
Smart Communications, PowerLink 100 and PowerLink 50, Product Information 27
E50405-U53-X-B3-7670, Edition 11.2014
To Next Page
Loading...
Need help?
General
